Clean your firearm as soon as possible after use. Your firearm should be inspected and cleaned periodically to ensure that it remains in good condition. With proper maintenance and care, your Mossberg® firearm will provide you with years of dependable service. Further disassembly should only be performed at the factory or by a qualified gunsmith. 11 - Elevator removal Remove the forearm/action slide assembly by sliding it forward and off the magazine tube.Ī CAUTION: Field disassembly is now complete! The shotgun should not be disassembled further for routine cleaning or maintenance. Squeeze the two arms which form the open end of the elevator assembly together sufficiently to disengage and remove the elevator from the receiver (Fig. Pivot the front portion of the elevator upward out of the receiver (Fig. NOTE: The safety button located on the upper rear of the receiver must be fully rearward in the "ON" (SAFE) position to remove the elevator assembly (Fig.2). Remove the bolt assembly by sliding it forward and out of the receiver assembly through the barrel opening at the front of the receiver (Fig. When the bottom of the bolt slide is aligned with the clearance cuts in the sides of the receiver, lift the bolt slide upward and out of the receiver (Fig. Move the forearm/action slide assembly rearward so that the bolt assembly and bolt slide are three quarters of the way rearward. (It may be necessary to tap the sides of the receiver lightly to release these parts) (Fig. Remove the cartridge interrupter from the ejection port side and cartridge stop from the opposite side. CAUTION: Pay special attention to the position of the bolt, bolt slide and action slide bar assembly during this portion of the disassembly, as the parts must be in the same relationship during reassembly.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |